User Tools

Site Tools


doc:appunti:hardware:olympus-e-m10:olympus_e_m10_mark_ii_failuers

This is an old revision of the document!


Olympus E-M10 Mark II failures

M.Zuiko Digital ED 12-42 Pancake Lens

After less than three years of use (FIXME how many shutter releases?) the M.Zuiko 12-42mm pancake lens failed. When you turn on the camera the lens moves, but it is not aknowledged by the camera and the LCD monitor remains black.

I purchased a second-hand replacement (same brand and model) which was in a excellent condition, almost like new. Unfortunately also this lens after three years of use failed like the first one.

LCD Monitor

After about four and a half years (FIXME How many shutter activations?), the LCD monitor cable broke. Initially, the monitor would shut off when I rotated it from its resting position, but then the failure began to occur more and more frequently until the monitor was permanently off.

I purchased a replacement cable from a Chinese seller on the Aliexpress online store, the cost was just 5 € shipping included. Disassembling the monitor and replacing the cable is a job of medium difficulty, you can find some howto videos online. The result was very satisfactory. The careful disassembly did not damage the various components, and after reassembly, the camera was undamaged and fixed.

Shutter actuations hidden menu

  1. Turn the camera ON while holding down the MENU button;
  2. Once the LCD screen lights up, release the MENU button and then press it again briefly;
  3. Use the arrow pad to move DOWN to the SPANNER item in the menu and press RIGHT;
  4. Use the arrow pad to move DOWN to the BRIGHTNESS item in the menu and press RIGHT;
  5. Press INFO;
  6. Press OK, and a screen showing the camera designation will come up;
  7. Press arrow pad UP;
  8. Press arrow pad DOWN;
  9. Press arrow pad LEFT;
  10. Press arrow pad RIGHT;
  11. Press the SHUTTER RELEASE button;
  12. Press arrow pad UP (a PAGE 1 with some abbreviations and numbers appears);
  13. Press arrow pad RIGHT to move to PAGE 2;
  14. Write down the number to the right of “R” of “MS” on PAGE 2. This is the number of shutter releases (the number to the right of “S” is the number of times the flash has fired);
  15. Switch the camera Off to revert back to normal operating mode. Congratulations, you have successfully retrieved the shutter count information!
Hidden menu codes
Letter Interpretation
R or MS Total shot count
S Total shots with flash
C (unknown)
U Switch On count
V (unknown)
B Total shots with IBIS
L (unknown)
doc/appunti/hardware/olympus-e-m10/olympus_e_m10_mark_ii_failuers.1762774579.txt.gz · Last modified: by niccolo