tecnica:motori:obd-ii
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
tecnica:motori:obd-ii [2018/08/03 12:20] – [Toyota Yaris 2006 1.0 1KR-FE Engine] niccolo | tecnica:motori:obd-ii [2018/08/03 17:21] – niccolo | ||
---|---|---|---|
Line 11: | Line 11: | ||
^ Fuel trim | Fuel trim is an adaptive strategy that adjusts fuel injector pulse width (open time) to adapt to wear, defects, or changes in the system. There is a short term fuel trim STFT and a long term fuel trim LTFT strategy. | ^ Fuel trim | Fuel trim is an adaptive strategy that adjusts fuel injector pulse width (open time) to adapt to wear, defects, or changes in the system. There is a short term fuel trim STFT and a long term fuel trim LTFT strategy. | ||
^ Closed loop mode | In closed loop mode the vehicle is adjusting air/fuel mixtures based on the real time results it’s getting from the oxygen sensors. Engine stays in open loop for a few minutes, until oxygen sensor reaches its working temperature, | ^ Closed loop mode | In closed loop mode the vehicle is adjusting air/fuel mixtures based on the real time results it’s getting from the oxygen sensors. Engine stays in open loop for a few minutes, until oxygen sensor reaches its working temperature, | ||
- | ^ Misfire | + | ^ Misfire |
+ | ^ Bank 1 and 2 | There are a number of OBD-II trouble codes that refer to either Bank 1 or Bank 2. Bank 1 refers to the side of the engine that has the #1 cylinder, Bank 2 is the opposite side of the engine. | ||
===== Toyota Yaris 2006 1.0 1KR-FE Engine | ===== Toyota Yaris 2006 1.0 1KR-FE Engine | ||
- | ==== Available Sensors (PIDs) ==== | + | We tried the **iLC OBD2** adapter (WiFi version) along with the Android app **[[https:// |
+ | ==== OBD-II | ||
* Intake Manifold Pressure(kPa) | * Intake Manifold Pressure(kPa) | ||
Line 21: | Line 23: | ||
* O2 Volts Bank 1 sensor 1(V) | * O2 Volts Bank 1 sensor 1(V) | ||
- | ==== Unavailable Sensors (PIDs) ==== | + | ==== OBD-II |
* Fuel pressure(kPa) | * Fuel pressure(kPa) | ||
+ | * Fuel trim bank 1 sensor 2(%) | ||
+ | * Fuel trim bank 1 sensor 3(%) | ||
+ | * Fuel trim bank 1 sensor 4(%) | ||
+ | * Fuel trim bank 2 sensor 1(%) | ||
* O2 Sensor1 Equivalence Ratio | * O2 Sensor1 Equivalence Ratio | ||
Line 34: | Line 40: | ||
* **[[https:// | * **[[https:// | ||
* **[[http:// | * **[[http:// | ||
+ | * **[[http:// |
tecnica/motori/obd-ii.txt · Last modified: 2018/08/04 07:33 by niccolo