doc:appunti:hardware:raspberrypi_air
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
doc:appunti:hardware:raspberrypi_air [2018/08/28 11:45] – [BME280 Barometric Sensor] niccolo | doc:appunti:hardware:raspberrypi_air [2018/10/03 06:00] – [Basic Raspbian Setup] niccolo | ||
---|---|---|---|
Line 80: | Line 80: | ||
</ | </ | ||
- | Edit **/ | + | Edit **/ |
+ | |||
+ | < | ||
+ | http { | ||
+ | #access_log / | ||
+ | #error_log / | ||
+ | access_log syslog: | ||
+ | error_log syslog: | ||
+ | } | ||
+ | </ | ||
===== DS3231 RTC Clock ===== | ===== DS3231 RTC Clock ===== | ||
Line 94: | Line 103: | ||
===== Python Libraries ===== | ===== Python Libraries ===== | ||
- | The **Adafruit library for the GPIO** lines is required by the Adafruit BME280 library to access I2C bus: | + | The **Adafruit library for the GPIO** lines is required by the Adafruit BME280 library to access I2C bus. It is advisable to install also some packages **from the Raspbian distro**, otherwise the python setup will try to download and install a local version: |
+ | |||
+ | < | ||
+ | apt-get install python-dev python-setuptools python-spidev | ||
+ | </ | ||
+ | |||
+ | The Adafruit Python library is installed from the Git repository: | ||
< | < | ||
Line 103: | Line 118: | ||
</ | </ | ||
+ | The setup procedure will download and install also the **Adafruit_PureIO** library. Everything will be installed into the **/ | ||
===== Serial Line ===== | ===== Serial Line ===== | ||
Line 464: | Line 480: | ||
==== Export to DXF ==== | ==== Export to DXF ==== | ||
- | In OpenSCAD we use the menu //Design// -> //Compile and Render | + | In OpenSCAD we use the menu //Design// -> //Render//. If the object is only bi-dimensional it will be rendered with a red outline and cyan filling. Only in this case we will be able to //File// -> //Export// -> //Export as DXF...//. |
==== Using Inkscape to add writings, logos and to layout the pieces ==== | ==== Using Inkscape to add writings, logos and to layout the pieces ==== |
doc/appunti/hardware/raspberrypi_air.txt · Last modified: 2020/08/14 10:17 by niccolo