doc:appunti:hardware:mxq_s805
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
doc:appunti:hardware:mxq_s805 [2017/08/23 11:33] – [Unsolved problems] niccolo | doc:appunti:hardware:mxq_s805 [2017/08/23 12:02] – [Video Resulution] niccolo | ||
---|---|---|---|
Line 20: | Line 20: | ||
The device does not have a clock inside, it relies on the time it gets from the internet. With the latest firmware (2016-01-26) there is a **very annoying bug**: from the Android settings we enabled **time from the internet** and set the proper timezone, this settings works just once, after a reboot the time is **almost always unset**. | The device does not have a clock inside, it relies on the time it gets from the internet. With the latest firmware (2016-01-26) there is a **very annoying bug**: from the Android settings we enabled **time from the internet** and set the proper timezone, this settings works just once, after a reboot the time is **almost always unset**. | ||
+ | |||
+ | ===== Video Resolution ===== | ||
+ | |||
+ | We don't know the actual **video adapter capabilities** of the MXQ, using the LibreELEC distribution we suspect that it cannot cope well with the native resolution of any HDMI monitor we connect to it. For example we attached a Samsung SyncMaster capable of 1440x900 pixel, but the Kodi interface offered only **1920x1080**, | ||
+ | |||
===== Partitions and storage space ===== | ===== Partitions and storage space ===== | ||
Line 197: | Line 202: | ||
The **power button of the remote control** does power off the device, but it is unable to wake it up. You must disconnect the power supply and connect it again. | The **power button of the remote control** does power off the device, but it is unable to wake it up. You must disconnect the power supply and connect it again. | ||
+ | |||
+ | Sometimes we get **Kodi reboot**, Kodi interface or **video play freeze**. The system is installed into the NAND memory, into the dmesg log there are plenty of that messages: | ||
+ | |||
+ | < | ||
+ | nftl _nand_discard, | ||
+ | nftl _nand_discard, | ||
+ | nftl _nand_discard, | ||
+ | </ | ||
+ | |||
+ | The Kodi program crashes with the following message: | ||
+ | |||
+ | < | ||
+ | Program terminated with signal SIGBUS, Bus error. | ||
+ | </ | ||
+ | |||
+ | May be there are problems with NAND memory? FIXME Must investigate running the same releas from SD card and/or running a different release from NAND. | ||
=== LibreELEC-S805.arm-8.2-8.1.5-HD18Q === | === LibreELEC-S805.arm-8.2-8.1.5-HD18Q === | ||
Line 204: | Line 225: | ||
=== LibreELEC-S805.m201d.arm-7.0.3.3d.img === | === LibreELEC-S805.m201d.arm-7.0.3.3d.img === | ||
- | We disabled [[wp> | + | We disabled |
< | < |
doc/appunti/hardware/mxq_s805.txt · Last modified: 2020/01/27 12:01 by niccolo