doc:appunti:hardware:kingelon_g9000
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revision | Next revisionBoth sides next revision | ||
doc:appunti:hardware:kingelon_g9000 [2015/03/09 16:06] – [Disassembling the G9000] niccolo | doc:appunti:hardware:kingelon_g9000 [2015/03/09 16:50] – [Disassembling the G9000] niccolo | ||
---|---|---|---|
Line 510: | Line 510: | ||
{{.: | {{.: | ||
{{.: | {{.: | ||
+ | |||
+ | Remove the 10 screws which keep the back frame. Divaricate the metal-plated frame from the screen glass using your thumb' | ||
+ | |||
+ | The **power board** at the bottom is secured with a single **screw**. Before removing it, detach the **antenna cable** and pull the **vibrator** out from its seat, where is secured with some adhesive. | ||
{{.: | {{.: | ||
{{.: | {{.: | ||
{{.: | {{.: | ||
+ | |||
{{.: | {{.: |
doc/appunti/hardware/kingelon_g9000.txt · Last modified: 2017/11/17 12:27 by niccolo