doc:appunti:hardware:kingelon_g9000
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
doc:appunti:hardware:kingelon_g9000 [2015/03/08 15:25] – [Disassembling the G9000] niccolo | doc:appunti:hardware:kingelon_g9000 [2015/03/09 16:50] – [Disassembling the G9000] niccolo | ||
---|---|---|---|
Line 501: | Line 501: | ||
===== Disassembling the G9000 ===== | ===== Disassembling the G9000 ===== | ||
- | After three months of use, the phone started | + | After three months of use, the phone started |
+ | |||
+ | Sometimes **the orange LED did not light-up** when the power adapter was plugged; sometimes a crazy loop of messages //charger plugged// - //charger unplugged// begun, which can result in phone crash. Sometimes, when the phone was plugged for the nightly charge, the orange LED turned on, but the morning after the phone was completely discharged ad the LED was off. Sometimes applying a light force to the USB connector (blending it toward the back of the phone) seemed to help, but everything was extremly unreliable. | ||
+ | |||
+ | It was not a cable or connector problem, it turned out that the power connector required a **soldering | ||
{{.: | {{.: | ||
{{.: | {{.: | ||
{{.: | {{.: | ||
+ | |||
+ | Remove the 10 screws which keep the back frame. Divaricate the metal-plated frame from the screen glass using your thumb' | ||
+ | |||
+ | The **power board** at the bottom is secured with a single **screw**. Before removing it, detach the **antenna cable** and pull the **vibrator** out from its seat, where is secured with some adhesive. | ||
{{.: | {{.: | ||
{{.: | {{.: | ||
{{.: | {{.: | ||
+ | |||
{{.: | {{.: |
doc/appunti/hardware/kingelon_g9000.txt · Last modified: 2017/11/17 12:27 by niccolo