doc:appunti:hardware:cisco_router
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionLast revisionBoth sides next revision | ||
doc:appunti:hardware:cisco_router [2013/02/13 16:53] – [VLAN] niccolo | doc:appunti:hardware:cisco_router [2016/09/21 12:59] – [SNMP] niccolo | ||
---|---|---|---|
Line 121: | Line 121: | ||
Vedere **[[http:// | Vedere **[[http:// | ||
- | In questo esempio si configura un pool pari a tutta la ntework **192.168.2.0/ | + | In questo esempio si configura un pool pari a tutta la ntework **192.168.2.0/ |
< | < | ||
#configure terminal | #configure terminal | ||
- | (config)#ip dhcp excluded-address 192.168.2.1 | + | (config)#ip dhcp excluded-address 192.168.2.1 |
- | (config)#ip dhcp pool CLIENT | + | (config)#ip dhcp pool DHCP-POOL |
(dhcp-config)# | (dhcp-config)# | ||
(dhcp-config)# | (dhcp-config)# | ||
- | (dhcp-config)# | + | (dhcp-config)# |
(dhcp-config)# | (dhcp-config)# | ||
(dhcp-config)# | (dhcp-config)# | ||
Line 298: | Line 298: | ||
ip address 172.16.1.1 255.255.255.0 | ip address 172.16.1.1 255.255.255.0 | ||
... | ... | ||
+ | </ | ||
+ | |||
+ | **ATTENZIONE**: | ||
+ | |||
+ | ====== SNMP ====== | ||
+ | |||
+ | Esempio per abilitare il monitoraggio via SNMP, community **public** in sola lettura, filtrato con una access list: | ||
+ | |||
+ | < | ||
+ | Router# | ||
+ | Router(config)# | ||
+ | Router(config)# | ||
+ | </ | ||
+ | |||
+ | ====== Backup/ | ||
+ | |||
+ | Predisporre una connessione LAN tra il router ed un host con un server TFTP (es. **tftpd-hpa** in Debian). Viene chiesto l' | ||
+ | |||
+ | < | ||
+ | copy run tftp | ||
+ | </ | ||
+ | |||
+ | La procedura inversa: | ||
+ | |||
+ | < | ||
+ | copy tftp run | ||
+ | copy run start | ||
</ | </ |
doc/appunti/hardware/cisco_router.txt · Last modified: 2019/02/02 14:20 by niccolo