doc:appunti:hardware:baofeng_bf888s
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
doc:appunti:hardware:baofeng_bf888s [2016/08/04 11:45] – [TODO] niccolo | doc:appunti:hardware:baofeng_bf888s [2016/08/05 12:25] – [TODO] niccolo | ||
---|---|---|---|
Line 107: | Line 107: | ||
^ Cross | Viene usato un mix di sistemi di squelch, differenziati fra trasmissione e ricezione. | ^ Cross | Viene usato un mix di sistemi di squelch, differenziati fra trasmissione e ricezione. | ||
- | ===== TODO ===== | + | ===== Hot to use the scan function |
- | | + | When the **scan function** is active, the receiver searches more than one channel for a valid transmission, |
- | * FIXME Verificare la funzione | + | |
- | * FIXME Verificare la funzione | + | |
+ | - Using Chirp, in the // | ||
+ | | ||
+ | - Turn on the radio and set it on **channel 16**: the **green LED will start to blink** while searching for a valid transmisson. When a valid signal is received (green LED steady on), you can push the PTT and respond on the same channel. After a few seconds of inactivity the radio will start to scan again (green LED blinking again). | ||
+ | |||
+ | The scan function on channel 16 can be **disabled** or **enabled** without using the Chirp software: | ||
+ | |||
+ | - Turn off the radio. | ||
+ | - Select channel 16. | ||
+ | - While pressing the **PTT and MONI buttons**, turn on the radio. | ||
+ | - The **voice prompt will say ON or OFF** (quite bad voice, it is not easy to understand). | ||
+ | - Even if you do not understand the voice, you can see if scan is active by the green LED blinking or not. | ||
+ | |||
+ | ===== La funzione battery saver ===== | ||
+ | |||
+ | Nel programma Chirp, tab // | ||
+ | |||
+ | Dalla (poca) documentazione disponibile si evince che dovrebbe funzionare quando la radio è in ricezione e non viene captato un segnale abbastanza forte per alcuni secondi; la radio inizia ad alternare momenti in cui è accesa e momenti in cui è spenta. | ||
+ | |||
+ | Il rischio è ovviamente quello di perdere una trasmissione che dura solo pochi secondi, durante il tempo in cui la radio è spenta. Non si conosce esattamente il periodo (in secondi) di ON e di OFF, altri modelli (es. [[http://wiki.radioreference.com/index.php/Baofeng_UV-5R#Battery_Saver|Baofeng UV-5R]]) hanno livelli di battery saver diversi, dal più blando 2-ON/13-OFF al più aggressivo 2-ON/ | ||
+ | |||
+ | Durante la funzione scan il battery saver viene disattivato. | ||
===== Riferimenti web ===== | ===== Riferimenti web ===== | ||
doc/appunti/hardware/baofeng_bf888s.txt · Last modified: 2018/03/28 11:15 by niccolo